Cutter bug with ACVCHD from Lumix Cams

The world's first H.264 AVCHD accurate cutter without re-encoding!
Smart Cutter and Mate for DV and DVB.
Smart products manages, splits, joins movies from DV Camcorder and DVB HD PVR.
Post Reply
CHB
Posts: 12
Joined: Thu Aug 26, 2010 10:52 pm

Cutter bug with ACVCHD from Lumix Cams

Post by CHB »

I'm sure at least V1.2 of smart cutter worked fine with these videos, but the resent V1.34 has serious troubles with AVCHD lite movies from Lumix Cams (TZ7 and TZ10). The movies can be handled just like any other movie, but the cut result hangs for a second or so at the start cutting point. To be exact: the rendered movie part works fine (the part that has the watermark in the demo mode), than the movie hangs for a second or so and then the movie continues.

Please find a sample movie and the result on the FTP-Server under "LUMIX AVCHD".
CHB
Posts: 12
Joined: Thu Aug 26, 2010 10:52 pm

Re: Cutter bug with ACVCHD from Lumix Cams

Post by CHB »

Additional finding:
If I select Autodeinterlace, the problem seem to disappear. BUT this options is not stored. If I open the options, select the autodeinterlace option, click ok and reopen the options, the check signal disappeared again.
CHB
Posts: 12
Joined: Thu Aug 26, 2010 10:52 pm

Re: Cutter bug with ACVCHD from Lumix Cams

Post by CHB »

Dear admin-team,

did you check this issue?
admin
Site Admin
Posts: 740
Joined: Mon Jun 01, 2009 12:54 pm

Re: Cutter bug with ACVCHD from Lumix Cams

Post by admin »

Dear CHB:
Sorry for the latency.

We did re-produce the problem on our end, but we are still looking for the reason.
We will keep you posted about the progress.

Please feel free to send us your further advice and suggestion.
Thank you very much.

Best Regards,
FameRing Support Team
admin
Site Admin
Posts: 740
Joined: Mon Jun 01, 2009 12:54 pm

Re: Cutter bug with ACVCHD from Lumix Cams

Post by admin »

Dear CHB:
Sorry for the latency.

We now have a new version for the problem, may you please try it on your end
http://www.fame-ring.com/smart.cutter.rar

Please feel free to send us your further advice and suggestion.
Thank you very much.

Best Regards,
FameRing Support Team
Post Reply